BW Technologies MicroClip XT Specifikace stáhnout pdf (Strana 61)

GasAlertMicroClip XT

Technical Reference Guide

Table 13. Replacing a Sensor or Sensor Filter

1. Deactivate the detector. On a clean surface, place the

detector face down.

2. Remove the six machine screws on the rear shell.

3. Remove the back cover by lifting the top and the bottom

upwards simultaneously to prevent damaging the char-

ger pins.

Replacing the Sensor Filter

1. Note the placement of the PCB to ensure it is replaced

correctly. Remove the two screws on the PCB. Remove

the PCB carefully.

a Caution

Ensure no damage occurs to the battery.

2. Remove the old sensor filter. It may be stuck to the sen-

sors.

3. Insert the new sensor filter.

Note

When inserting a new sensor filter, ensure the black gasket is

facing the front shell.

4. To complete the detector, refer to Reassembling the

detector.

Replacing the H

S, CO, and LEL sensor

1. Note the placement of the PCB to ensure it is replaced

correctly. Remove the two screws on the PCB. Remove

the PCB carefully.

a Caution

Ensure no damage occurs to the battery.

If the sensor filter is stuck to the sensors, remove and replace the

sensor filter into the front shell.

2. Slide the sensors out.

Item Description

1 Front shell

2 Combustible (LEL) sensor

3PCB

4 PCB screws (2)

5 Rear shell

6 Machine screws (6)

7 Sealing rib

8 Carbon monoxide (CO) sensor

Hydrogen sulfide (H

S) sensor

Oxygen (O

) sensor

11 Sensor filter

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 73 74

Komentáře k této Příručce

Žádné komentáře

BW Technologies MicroClip XT Specifikace Strana 61

Komentáře k této Příručce